Filter
Top Products
BE-1204B-BC • BE-1206B-BC 2-5
Chapter 2 Preparation of Embroidery Machine
2-2 Installation of Machine
W1224Q
1. Place Footboard [4], a rubber cushion 10 [3] (provided with the machine), and PE sheet [2] under
each of four adjustment bolts M20 [1]. The Footboard must be on the rubber cushion.
2. Fit four adjustment bolts M20 [1] into the hole of Footboard [4], and adjust the embroidery machine
in height.
The adjustment must be made in such a manner that the four bolts are under an equal load when
the machine is placed down. (To lower adjustment bolt M20 [1], turn it in the direction of the arrow.)
Also, the casters should be raised.
3. After adjusting four adjustment bolts M20 [1], turn nuts M20 [5] in the direction of the arrow to
fasten them.
If the floor is not strong enough, the embroidery machine may be rocked during operation. In such a
case, it is recommended that a secure base of concrete be placed below the embroidery machine.
[5]
[1]
[4]
[3]
[2]