Filter
Top Products
BE-1204B-BC • BE-1206B-BC 3-3
Chapter 3 Embroidering Procedures
Checks the embroidering area.
Exits from embroidering mode. Press this switch while holding down switch simultaneously to stop
embroidering.
Moves the hoop automatically into the embroidering area when the embroidery position is out of the area.
When this switch is pressed while the computer has given a command to move embroidery hoop, the
embroidery hoop moves designated position.
Moves the hoop to software-set position. When this switch is pressed again, the hoop returns to the previous
position.
Clear inching when this switch is pressed in the inching mode.
Moves the needle bar. The needle moves by the diameter every time this switch is pressed.
Moves the hoop.
Step-back or forward is available during suspension. (Use
switches only.)
Changes the speed range during embroidering (Use switches only).
Sets machine to the inching mode when is pressed while holding down during suspension.
Carries out inching of the hoop when the switch is pressed in the inching mode. ( appears on the
panel)
Turning on the power with key pressed will display the test mode screen.
! Canceling errors
When an error message appears, it is canceled by pressing
switch.
Pressing other switches can stop alarm sound.
When thread breakage or wiper out error has occurred, step-back or forward switch can be used to
cancel errors.