Filter
Top Products
BE-1204B-BC • BE-1206B-BC 2-23
Chapter 2 Preparation of Embroidery Machine
!
!!
! Holder base (optional)
W1244Q
Attaching the holder base frame
1. Set the table. (Refer to “Mounting of Table” on page 2-7.)
2. Insert the frame connecting plate F [4] into the holder base frame L [1], flat frame C6-360 [2] and
holder base frame R [3], using bolts and washers.
[When using the machine only with the holder base frame (small)]
Attach the flat frame S connecting plates L [5] and R [6] to the flat frame S6-360 set [7].
Attach the flat frame S connecting plates L [5] and R [6] to the holder base frames L [1] and R [3], using
bolts of 4×12 and washers of middle 4.
3. Remove 4 bolts [9] from the front of X-feed sash [8].
4. Put the frame connecting plates L [10] and R [11] on the X-feed sash [8]. Fix them with bolts and
washers.
5. Check that the clearance between the mounted flat frame C6-360 [2] and the table is even when
viewed from the machine front.
If adjustments are needed, loosen bolts of the F table support Front [12] and move it in the
direction of the arrow.
6. Tighten each bolt securely after the adjustment is completed.
[9]
[2]
[4]
[3]
[5]
[1] [3]
Y
-axis cover
1mm 1mm
Felt
Table
[11]
[1]
[6]
[7]
[12]
[10]
[9]
[8]