Filter
Top Products
BE-1204B-BC • BE-1206B-BC 11-5
Chapter 11 Error code list
Code Error Measures
E-B2 Hook motor home position error
E-B3 Hook motor standby position error
E-B4 Hook motor motor mode error
E-B5 Hook motor communication error
E-B6 Hook motor parameter error
E-B7 Hook motor overheat error
E-B8 Hook motor overcurrent error
This is not displayed in this model.
E-B9 Thread trimming motor zero point error
Turn the power off and on once. If the same error occurs
again, the lower shaft motor is faulty.
E-BA Power supply frequency error
Turn the power off and check the thread trimmer and turn the
power on again. If it occurs again, the thread trimmer is faulty.
E-BC No power error
It may usually occur momentarily when turning off the machine.
If it occurs when the machine is on, it is a power failure
detection error.
E-BD Lower shaft flash memory error
E-BE Lower shaft version-up error
E-BB,
BF
Lower shaft motor undefined error
E-C1 Area over during embroidering
This is not displayed in this model.
E-C2 Wiper out error
If the wiper is tangled with a thread, remove it. Press the
or turn on the F/B switch on the head to either side.
E-C3 Embroidering data buffer empty
Check the connection of the communication cable of the panel.
If the cable is connected correctly , press the
or turn on
the F/B switch on the head to either side. If the cable is
disconnected , turn off the power and connect the cable.
E-C4 Presser foot down error
E-C5
Measured voltage value could not be received
form the lower shaft motor CPU.
E-C6
Voltage value could not be transferred to the
lower shaft motor CPU.
E-C7 Lower shaft error
E-C8 Hook motor home position error
E-C9 Embroidering start error
E-CA No sewing permisson
This is not displayed in this model.
E-CB Spindle rotation speed error
Press the
or turn on the F/B switch on the head to either
side to cancel the error and press the
. If the same error
occurs again, there is a possibility that the spindle is
overloaded.
E-CC Shuttle thread entanglement automatic reset This is not usually displayed.
E-CD Speed command can not be received.
Turn the power off and on once. If the same error occurs
again, the main PCB is faulty.
E-CE Cylinder bed position error
E-CF
Rated voltage value could not be received from
the lower shaft motor CPU.
This is not usually displayed.
E-D0 Power PC board error
Turn the power off and on once. If the same error occurs
again, the power PCB is faulty.
E-D1 Cooling fan motor stop. This is not usually displayed.