Filter
Top Products
BE-1204B-BC • BE-1206B-BC 11-3
Chapter 11 Error code list
Code Error Measures
E-13
This is displayed in case that the machine had
been shut down while the hoop was moving
and now is started up in a mode without the
home position detection, or in case that the
machine is started up in a mode without the
home position detection after pressing the CAP
SW to change the hoop.
Press the
to start the home position moving.
E-14 Y-axis home position error
Turn the power off and on once. If the same error occurs
again, the Y-axis mechanism is faulty.
E-15
Stop error during SSP processing (when
pressing the stop key while the hoop is moving)
Hoop movement restarts if you press
.
E-16
Needle bar No. of the destination is out of
range
Press the
, or turn ON the F/B switch on the head to either
side to cancel the error and set up the needle bar setting again.
E-17 Speed range is out of range This is not usually displayed.
E-18 X-axis stepping motor connector error
Turn the power off and on once after checking to see that the
connector of the X-axis stepping motor is properly connected.
E-1A Destination coordinates error
E-1B
The machine has reached the mending stop
position.
This is not usually displayed.
E-1C The machine stops during mask tracing.
Tracing is cancelled if the
key is pressed when the
machine is stopped during mask tracing. Press the
key
to continue tracing.
E-1D
The machine stops while the needle is moving
between patterns during repeat sewing.
This is displayed when the stop switch is pressed while the
hoop is moving. Press the
to move the hoop again. (It
is necessary to press the
again to start sewing.)
Errors E-1C and E-1D are not displayed due to mechanical problems.
E-1E
When the power is turned on, bed can not be
retracted.
E-1F
Presser foot down error while searching for
home position just after the power is turned on.
This is not displayed in this model.
E-21 Hoop overhang (+X)
E-22 Hoop overhang (+Y)
E-23 Hoop overhang (+X, +Y)
E-24 Hoop overhang (-X)
E-25 Hoop overhang (+X, -X)
E-26 Hoop overhang (-X, +Y)
Pattern or the needle position is out of the embroidering area.
Reset the embroidering area with the PC or move the hoop to
the sewable position.
E-27 Hoop overhang (+X, -X, +Y)
E-28 Hoop overhang (-Y)
E-29 Hoop overhang (+X, -Y)
Pattern or the needle position is out of the embroidering area.
Reset the embroidering area with the PC or move the hoop to
the sewable position.
E-2A Hoop overhang (+Y, -Y)
E-2B Hoop overhang (+X, +Y, -Y)
E-2C Hoop overhang (-X, -Y)
E-2D Hoop overhang (+X, -X, -Y)
E-2E Hoop overhang (-X, +Y, -Y)
E-2F Hoop overhang (+X, -X, +Y, -Y)
E-31 Needle overhang (+X)
E-32 Needle overhang (+Y)
E-33 Needle overhang (+X, +Y)
E-34 Needle overhang (-X)
Pattern or the needle position is out of the embroidering area.
Reset the embroidering area on the panel or move the hoop to
the sewable position.