Filter
Top Products
6-6 BE-1204B-BC • BE-1206B-BC
Chapter 6 Embroidering
Settings before Turning On the Machine
Describes settings available before the machine is turned on.
! The following items can be set.
• Displaying the tool bar
• Displaying the status bar
• Upgrading the version of interface board (*)
• Resetting the interface board (*)
• Communication port
• Language
(*) Dealer engineers carries out version upgrading and resetting of the interface board.
Displaying the Tool Bar
Shows/hides the tool bar. The tool bar contains icons with the same functions as the menu.
! There are two kinds of tool bars as follows:
Main Main menu items are displayed on this tool bar.
Step Back This tool bar appears during step-back/forward.
1. Select [Tool Bar] from View menu and put the check mark.
Click here again to remove the check mark. Then the tool bar disappears.
W1061Q