Filter
Top Products
Sending Documents
4‑56
Job Recall
You can recall the last three destinations, scan settings, and send settings that have
been set, and then send your documents.
The machine considers any one of the following operations a send job:
When settings, such as the destination, scan settings, and send settings, are specified, and the control panel
power switch, (Start), or (Reset) is pressed
When the Auto Clear mode activates after the send settings are specified
The Standard mode is not stored in Recall memory.
The three most recent settings that were stored in memory are not erased even when the power is turned off.
–
–
–
–
–
1 Press (SEND).
2 Place your originals.
3
4
① Select [1 Before], [2 Before], or [3 Before].
② Confirm the settings, then press [OK].
If there are more stored Send settings
than are currently displayed, you can scroll
through the list by pressing [▼] or [▲].
You can change the settings for a recalled
send job.
If there are multiple destinations stored
in Recall memory, the order of the
destinations shown in the list may not
correspond to the order in which they were
specified.
5 Press (Start).
If the original is placed on the platen glass,
follow the instructions that appear on the
touch panel display, then press (Start) once
for each original. When scanning is complete,
press [Done].
Scanning starts.
The scanned data is sent to the specified
destination when scanning is complete.
–
–
–