Filter
Top Products
Troubleshooting
6
6-6
lever is down. (ÆP.2-15)
Problem 7: An ink tank has run out of ink or the nozzles of the printhead are clogged.
Solution: Print a nozzle check pattern to confirm the ink supply and condition of the
printhead.
If an ink tank has run out of ink, replace the ink tank. (ÆP.5-2)
If you determine that the nozzles are clogged, clean the printhead. (ÆP. 6-
23)
Printing Halts During Print Job
Error message is displayed.
Problem 1: An error message is displayed during printing.
Solution: Read the message displayed in the NetSpot and correct the problem
indicated by the error message. (ÆP.6-11)
Problem 2: The selected Media Size is not correct for the media loaded in the paper
supply source.
Solution: Confirm the current selection for the Media Size. If the setting is not
correct, stop the print job, select the correct setting, then start the print job
again. (ÆP.2-7)
Problem 3: Bi-directional communication between the printer and computer cannot
execute when the printer is connected via the parallel port.
Solution: Open the Setup Menu on the printer operation panel, select Set Centronics
Interactive then select None. (ÆP. 4-9)
Blank paper is ejected from the printer.
Problem 1: A blank page is ejected from the previous print job.
Solution: The print job starts after the blank page is ejected.
Problem 2: Printhead nozzles are clogged.
Solution: Print a nozzle check pattern, check the condition of the printhead nozzles,
If you determine that the printhead nozzles are clogged, clean the
printhead. (ÆP.6-23)
Problem 3: Printer is damaged.
Solution: Call for service.
00_J80xUG_Eng.book Page 6 Friday, April 12, 2002 12:28 AM