Canon X600 Projector User Manual


 
User Command Specifications
9Details of command RANGE PROG
1
RANGE PROG
RANGE PROG
RANGEPROG
r:PROG=I, <Setting option 1>, <Setting option 2>, …, <Setting option n>
-1
A "busy" response is given while the zoom or focus lens is being driven.
With some input signals, it may not be possible to make this inquiry.
-2
> RANGE PROG
< r:PROG=I, 0, 1, 2
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ×
× ×
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
Command
s
supported
SX60 X600SX50 SX6
○○○○
Control Setting Reference
For all other responses, refer to "Error List."
Progressive setting option reques
t
ID
Mode
Commands
Function
Format
Example
Description
Response
This inquires about the parameter options which enable the progressive setting to be selected.
01.00** 01.01** 01.01** 01.01**
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
(Refer to the ZCONTDRV command and FCONTDRV command.)
The progressive setting can be selected by the PROG command.
Model Power
Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50
×××○○○––× ×
SX6
×××○○○××× ×
SX60
X600
PAGE 144