Filter
Top Products
User Command Specifications 9. Details of command ACADJUST
1
ACADJUST
ACADJUST
ACADJUST=<Advanced color adjustment paramete
r
：ＩＤ>
Advanced color adjustment parameters
Low memory color adjustment
Medium memory color adjustment
High memory color adjustment
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
-3
-4
-5
Control
> ACADJUST=MEM_M
< i:OK
Reference
> GET ACADJUST or ?ACADJUST This retrieves the color correction method.
< g:ACADJUST=6AX
Acquisition of parameters which can be set
> RANGE ACADJUST
<
* Commands are indicated by ">", and responses are indicated by "<".
When a command is not supported, "e:0002 INVALID_COMMAND" is returned.
Supported Command State
s
OFF ON PM
× ○ ×
–––
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
r:ACADJUST=I,NOCORRECT,MEM_L,MEM_M,MEM_H,6AX
This sets the currently selected input signal and image mode.
The GET command can be used to retrieve the current color compensation method.
01.00** 01.01** 01.01**
Commands
Function
Parameter
Description
Response
Format
SX6 SX60
Command
s
supported
Example
ID
Advanced color adjustmen
t
"i:OK" is returned if the parameter was set properly.
This command is identical to the Color balance function in the Image adj. menu.
In the case of "6-axis adjustment," set the hue and color saturation of each axis using the 6AX
R
to Y "6-axis correction R to Y hue/color saturation setting" commands.
Meaning
NOCORRECT No adjustmen
t
(Refer to the ZCONTDRV command and FCONTDRV command.)
××
Setting
X600
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
MEM_L
Paramete
r
6A
X
Mode Control
MEM_H
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
6-axis adjustmen
t
MEM_M
Reference
For all other responses, refer to "Error List."
The advanced color correction method is set by selecting from “No correction”, “Low to High
memory color correction”, and “6-axis adjustment”.
Model Power
Input
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video
Mode
Remote Local
Remarks
SCART None
SX50
×××○○○––
––– ––
SX6
––– –
○○
–
×
–
SX60
X600
"NO CORRECT," "MEM_L," "MEM_M,"
"MEM_H" or "6AX" can be set as the
color correction method.
×
For details, refer to the GET command.
SX50
The color correction is set to “Medium memory
color adjustment”.
01.01**
○
PAGE 42