Filter
Top Products
User Command Specifications 9. Details of command HPIX/VPIX
1
HPIX/VPIX
HPIX/ VPIX
HPIX=<Horizontal resolution: Number>
V
PIX=<Horizontal resolution: Number>
Horizontal/vertical resolution
-1
A "busy" response is given while the zoom or focus lens is being driven.
Furthermore, it may not be possible to execute the command with some input signals.
-2
Menu
[Display settings] - [Input signal settings] - [No. of horizontal display dots]
[Display settings] - [Input signal settings] - [No. of vertical display dots]
-3
Setting
> HPIX=1024 This sets the horizontal resolution to 1024.
< i:OK
Reference
> GET VPIX or ?VPIX This retrieves the vertical resolution.
<
g:VPIX= 864
Obtain settable parameter range (Min, Max)
> RANGE VPIX
< r:VPIX=N, 0, 1000
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
01.00** 01.01** 01.01** 01.01**
Commands
Function
Parameter
Description
Response
Format
Example
Horizontal/Vertical resolution adjustmen
t
"i:OK" is returned if the parameter was set properly.
This adjusts the horizontal and vertical resolution (number of dots) on the screen.
Model
SX50
SX6
SX60
The GET command can be used to retrieve the current horizontal and vertical position.
X600
SX50 SX6 SX60 X600
○○
Model Power
Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50
○○○×××––×○ ×
SX6
○○○××××××○ ×
SX60
X600
Control Setting Reference
For details, refer to the GET command.
This command is the same as the menu functions in the table below.
Number
Mode
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
The RANGE command can be used to obtain the parameter range that can be set at
that time.
Any value from 0 to 1000 can be set for the
horizontal resolution.
Command
s
supported
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
(Refer to the ZCONTDRV command and FCONTDRV command.)
[Display settings] - [Input signal settings] - [No. of horizontal dots]
[Display settings] - [Input signal settings] - [No. of vertical dots]
○○
PAGE 24