Filter
Top Products
User Command Specifications 9. Details of command HPOS/VPOS
1
HPOS/VPOS
HPOS/VPOS
HPOS=<Horizontal position: Number>
V
POS=<Vertical position: Number>
Horizontal/vertical positions
-1
A "busy" response is given while the zoom or focus lens is being driven.
Furthermore, it may not be possible to execute the command with some input signals.
-2
Menu
[Display settings] - [Input signal settings] - [Horizontal position]
[Display settings] - [Input signal settings] - [Vertical position]
-3
Setting
> HPOS=12 This sets the horizontal position to 12.
< i:OK
Reference
> GET VPOS or ?VPOS This acquires the vertical position.
< g:VPOS=8
Obtain settable parameter range (Min, Max)
> RANGE HPOS
< r:HPOS=N, 0, 820
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
SX60 X600SX50 SX6
Commands
Format
Mode
The GET command can be used to retrieve the current horizontal and vertical position.
SX60
X600
This command is the same as the menu functions in the table below.
"i:OK" is returned if the parameter was set properly.
This adjusts the horizontal and vertical position on the screen.
Function
Example
Model
SX50
SX6
Parameter
Response
Number
For all other responses, refer to "Error List."
Description
01.00** 01.01** 01.01** 01.01**
Model Power
Input
D-RGB A-RGB1 A-RGB2 Comp Video S-Video
Mode
Remote Local
Remarks
D-Video SCART None
SX50
× ○○×××––×○ ×
SX6
× ○○ × ○ ×××××
SX60
X600
×
Control Setting Reference
For details, refer to the RANGE command.
Horizontal/Vertical position adjustmen
t
The RANGE command can be used to obtain the parameter range that can be set at
that time.
[Display settings] - [Input signal settings] - [Horizontal position]
[Display settings] - [Input signal settings] - [Vertical position]
Command
s
supported
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
Any value from 0 to 820 can be set for the
horizontal position.
○○○○
PAGE 23