Filter
Top Products
User Command Specifications
9．Details of command GET DOTS
1
GET DOTS
GET DOTS
GET□DOTS
?△DOTS
g:DOTS=<Total number of dots: Number>
For all other responses, refer to "Error List."
-1
A "busy" response is given while the zoom or focus lens is being driven.
（Refer to the ZCONTDRV command and FCONTDRV command.）
With some input signals, it may not be possible to make this inquiry.
-2 The total number of dots can be set by the DOTS command.
> GET DOTS or ? DOTS
< g:DOTS=1200
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
××○ ×
–×○
X600
SX60
×××
SX6
× ○○×
×
SX50
× ○○×××
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
Power
Input Mode
Remote Local
Number
○○○○
This inquires about the current total number of dots.
01.00** 01.01** 01.01** 01.01**
Commands
Function
Format
Description
Response
Total number of dots inquir
y
Mode Control Setting Reference
–
Command
s
supported
This inquiry can be made when the projector is in both the remote mode and power-on status at
the same time.
Example
SX60 X600SX50 SX6
Model
PAGE 77