Filter
Top Products
User Command Specifications 9. Details of command NOSIG
1
NOSIG
NOSIG
NOSIG=<Parameters for setting display screen in no-signal mode：ＩＤ>
Parameters for setting display screen in no-signal mode
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[Display settings] - [User screen settings] - [Screen in no-signal mode]
[Display settings] - [User screen settings] - [Screen in no-signal mode]
-3
-4
Setting
> NOSIG=BLUE This sets the “Blue” screen when no signals are input.
< i:Ok
Reference
>
GET NOSIG or ?NOSIG This retrieves the screen when no signals are input.
< g:NOSIG=LOGO
Acquisition of parameters which can be set
> RANGE NOSIG
< r:NOSIG=I, BLACK, BLUE, LOGO
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
The GET command can be used to obtain the current display screen at no signal.
Model
SX50
SX6
SX60
X600
To select the user screen (LOGO), the user image must be registered ahead of time. (If the
user image is not registered, "e:1002 NO_LOGO_CAPTURED" is returned.)
Example
Commands
This command is the same as the menu functions in the table below.
Description
Response
LOGO
Function
BLACK
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
Format
Parameter
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
Display screen when no signal settin
g
Paramete
r
"i:OK" is returned if the parameter was set properly.
This sets the display screen when no image signals are input.
BLUE Blue screen
ID
Meaning
User screen
Black screen
01.00** 01.01** 01.01** 01.01**
SX50
○
SX6 SX60 X600
Model Power
Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50
○○○○○○––○○×
SX6
○○○ ○○×○○○○
SX60
X600
○
Mode Control Setting Reference
Command
s
supported
For all other responses, refer to "Error List."
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
"BLACK," "BLUE" or "LOGO" can be set for the display
screen in the no-signal mode.
○○○
PAGE 55