Filter
Top Products
User Command Specifications 9. Details of command AVOL
1
AVOL
AVOL
AVOL=<Audio volume level: Number
>
Audio volume level (0 to 20)
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
-3
Button
'VOL+' and 'VOL-' on the remote control
'VOL' on the remote control
-4
-5
Setting
> AVOL=18 This sets the volume to 18.
< i:OK
Reference
> GET AVOL or ?AVOL This retrieves the volume.
< g:AVOL=18
Obtain settable parameter range (Min, Max)
> RANGE AVOL
< r:AVOL=N,0,20 Any value from 0 to 20 can be set for the volume level.
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
SX50
The RANGE command can be used to obtain the parameter range that can be set at
that time.
The final beep sound setting is retained even when the power is turned off.
This command has the same function as the buttons listed in the table below.
The volume level can be set even while the sound is muted, but the sound will remain muted.
The GET command can be used to retrieve the current volume.
Example
"i:OK" is returned if the parameter was set properly.
This adjusts the volume.
SX50
SX6
Model
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
Commands
Function
SX60
X600
Audio volume adjustmen
t
Parameter
Description
Response
Number
Mode
○○
01.01** 01.01**01.01**01.00**
○○
Model Power
Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50
○○○○○○––○○×
SX6
○○○○○○○○○○×
SX60
Format
X600
SX6 SX60 X600
Control Setting Reference
Command
s
supported
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
(Refer to the ZCONTDRV command and FCONTDRV command.)
For details, refer to the GET command.
PAGE 49