Filter
Top Products
User Command Specifications 9. Details of command RESET
1
RESET
RESET
RESET□<Reset parameter
s
：ＩＤ>
Reset parameters
This resets the projector settings.
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
What can be specified by the reset parameters for each "reset type" is provided below.
■ Reset of lamp on time
(a) The counter indicating the lamp replacement period is reset.
(b)
(c) Execute this command after replacing the lamp.
■ Current image adjustment reset
(a) The adjustment settings of the currently-selected image mode are initialized.
(b) This command is identical to the Reset function in the Image adj. menu.
※
■ Reset of system settings
(a) The following items are initialized.
- Image adjustment items (all image modes)
- Initial settings executed
* For details, refer to 'RESET items' at the end of these specifications.
(b)
■ Factory settings
(a) The following items are initialized.
- Image adjustment items (all image modes)
- Initial settings executed
- Input source <-A-RGB2
- Language <- English
* For details, refer to 'RESET items' at the end of these specifications.
-3 Notes
(a)
(b)
(c)
Control
>
RESET LAMPTIME
This resets the lamp on time.
< i:OK
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
s
OFF ON PM
× ○ ×
× ○ ×
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
This command works in the same way as the menu [System settings] - [Initial settings]
function.
01.01** 01.01** 01.01**
'NO_SIGNAL' may be returned as the response to the command after 'Current image
adjustment reset' or 'System initial setting' has been executed.
SX50 SX6 SX60 X600
Mode
Current image adjustment reset
LAMPTIMELamp on time rese
t
An ‘i:OK’ is returned when the reset process is successful.
Furthermore, the internal status established when a response other than the normal response
("i:OK") has been returned is indeterminate.
For all other responses, refer to "Error List."
Control Setting
ReferenceCommands
Function
Parameter
Format
MeaningParamete
r
Rese
t
ID
IMAGE
SYSTEM Initial system settings
(Refer to the ZCONTDRV command and FCONTDRV command.)
If there is an input signal, the image adjustment items are initialized and then the
adjustment values are optimized for the signal.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
This command is identical to the Reset function under Lamp counter in the System
settings menu.
Description
Response
Factory settingsALL
Model Power
Input
D-RGB A-RGB1 A-RGB2 Comp Video
○
D-Video SCARTS-Video None
Remarks
Mode
Remote Local
○○○○
○
––○
○○○
○○ ×
SX6
○○○ ○○×○
SX50
SX60
X600
Command
s
supported
○○○○
Example
The power must never be turned off while this command is being executed!
01.00**
After the 'Factory settings,' be absolutely sure to turn the power off and then restart.
PAGE 47