Filter
Top Products
User Command Specifications 7. Power Management Mode
1 7. Power Management Mod
e
Concerning the processing for switching to the power management standby or exit mode in the remote or local mode
Events for returning from standby mode
・Signal inpu
t
・Pressing of a button on main unit or remote contro
l
Lamp on
・REMOTE command
・RC/MAIN command (excluding RC/MAIN*-REP
)
Lamp off
When the exit mode is established
Power Off
Remote
The countdown is aborted by any command other than
GET/RANGE.
Processing only for commands
enabled in power management
standby mode
Lamp
cooling in
progress
Projecting in
progress
When the standby
mode is established
Power management activated
7. Power Management Mode
SX50
(No countdown is initiated.)
The power management standby or exit mode is established when no signals are supplied for at least 5
minutes.
SX6/SX60/SX60
0
The power management standby or exit mode is
not established.
The power management standby or exit mode is
established when no si
g
nals are supplied for at least 5
Control is switched to the "local mode" in the standby or
exit mode.
Local
Mode
PAGE 11