Filter
Top Products
Performing Other Configuration Tasks
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
4-44
Step 3 Enter the show version command at the privileged EXEC mode prompt to
display the current software configuration register setting:
Router#show version
.
.
.
Make a note of this current configuration setting, as displayed in the last line of
the show version command output. You may need this value for later use (in
Step 13).
Step 4 If the Break function is disabled, power cycle the router by turning off power to
the power supply(ies), waiting 5 seconds, and then restoring power.
If the Break function is enabled, press the Break key or send a break signal by
holding down the Control key and pressing the right square bracket key (^]).
Step 5 Within 5 seconds of power being restored to the router, press the Break key. This
action causes the terminal to display the ROM monitor prompt, as follows:
rommon 1>
Step 6 Set the software configuration register to ignore the configuration file
information, as indicated in the following sample display:
rommon 1> conf reg
Configuration Summary
enabled are:
console baud: 9600
boot: image specified by the boot system command
or default to: cisco2-grp
do you wish to change the configuration? y/n [n]: y
enable “diagnostic mode”? y/n [n]:
enable “use net in IP bcast address”? y/n [n]:
enable “load rom after netbootfails”? y/n [n]:
enable “use all zero broadcast”? y/n [n]:
enable “break/abort has effect?” y/n [n]:
enable “ignore system config info?” [n]: y
change console baud rate? y/n [n]:
change boot characteristics? y/n [n]