Filter
Top Products
14-11
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
78-17058-01
Chapter 14 Configuring STP
Configuring Spanning-Tree Features
Configuring Spanning-Tree Features
These sections contain this configuration information:
• Default Spanning-Tree Configuration, page 14-11
• Spanning-Tree Configuration Guidelines, page 14-12
• Changing the Spanning-Tree Mode., page 14-13 (required)
• Disabling Spanning Tree, page 14-14 (optional)
• Configuring the Root Switch, page 14-14 (optional)
• Configuring a Secondary Root Switch, page 14-16 (optional)
• Configuring Port Priority, page 14-16 (optional)
• Configuring Path Cost, page 14-18 (optional)
• Configuring the Switch Priority of a VLAN, page 14-19 (optional)
• Configuring Spanning-Tree Timers, page 14-20 (optional)
Default Spanning-Tree Configuration
Table 14-3 shows the default spanning-tree configuration.
Table 14-3 Default Spanning-Tree Configuration
Feature Default Setting
Enable state Enabled on NNIs in VLAN 1.
For more information, see the “Supported
Spanning-Tree Instances” section on
page 14-10.
Spanning-tree mode Rapid PVST+
Rapid PVST+ interoperates with PVST and
PVST+. MSTP is disabled.
Switch priority 32768.
Spanning-tree port priority (configurable on a per-interface basis) 128.
Spanning-tree port cost (configurable on a per-interface basis) 1000 Mbps: 4.
100 Mbps: 19.
10 Mbps: 100.
Spanning-tree VLAN port priority (configurable on a per-VLAN basis) 128.
Spanning-tree VLAN port cost (configurable on a per-VLAN basis) 1000 Mbps: 4.
100 Mbps: 19.
10 Mbps: 100.
Spanning-tree timers Hello time: 2 seconds.
Forward-delay time: 15 seconds.
Maximum-aging time: 20 seconds.