Filter
Top Products
27-6
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
78-17058-01
Chapter 27 Configuring SNMP
Configuring SNMP
Configuring SNMP
These sections contain this configuration information:
• Default SNMP Configuration, page 27-6
• SNMP Configuration Guidelines, page 27-6
• Disabling the SNMP Agent, page 27-7
• Configuring Community Strings, page 27-8
• Configuring SNMP Groups and Users, page 27-9
• Configuring SNMP Notifications, page 27-11
• Setting the Agent Contact and Location Information, page 27-14
• Limiting TFTP Servers Used Through SNMP, page 27-15
• SNMP Examples, page 27-15
Default SNMP Configuration
Table 27-4 shows the default SNMP configuration.
SNMP Configuration Guidelines
If the switch starts and the witch startup configuration has at least one snmp-server global configuration
command, the SNMP agent is enabled.
An SNMP group is a table that maps SNMP users to SNMP views. An SNMP user is a member of an
SNMP group. An SNMP host is the recipient of an SNMP trap operation. An SNMP engine ID is a name
for the local or remote SNMP engine.
Table 27-4 Default SNMP Configuration
Feature Default Setting
SNMP agent Disabled
1
.
1. This is the default when the switch starts and the startup configuration does not have any snmp-server global configuration
commands.
SNMP trap receiver None configured.
SNMP traps None enabled except the trap for TCP connections (tty).
SNMP version If no version keyword is present, the default is Version 1.
SNMPv3 authentication If no keyword is entered, the default is the noauth (noAuthNoPriv)
security level.
SNMP notification type If no type is specified, all notifications are sent.