Filter
Top Products
36-6
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
78-17058-01
Chapter 36 Troubleshooting
Recovering from a Lost or Forgotten Password
Step 7 At the switch prompt, enter privileged EXEC mode:
Switch> enable
Step 8 Rename the configuration file to its original name:
Switch# rename flash:config.text.old flash:config.text
Step 9 Copy the configuration file into memory:
Switch# copy flash:config.text system:running-config
Source filename [config.text]?
Destination filename [running-config]?
Press Return in response to the confirmation prompts.
The configuration file is now reloaded, and you can change the password.
Step 10 Enter global configuration mode:
Switch# configure terminal
Step 11 Change the password:
Switch (config)# enable secret password
The secret password can be from 1 to 25 alphanumeric characters, can start with a number, is case
sensitive, and allows spaces but ignores leading spaces.
Step 12 Return to privileged EXEC mode:
Switch (config)# exit
Switch#
Step 13 Write the running configuration to the startup configuration file:
Switch# copy running-config startup-config
The new password is now in the startup configuration.
Note This procedure is likely to leave your switch virtual interface in a shutdown state. You can
identify this interface by entering the show running-config privileged EXEC command. To
re-enable the interface, enter the interface vlan vlan-id global configuration command, and
specify the VLAN ID of the shutdown interface. With the switch in interface configuration
mode, enter the no shutdown command.
Step 14 Reload the switch:
Switch# reload