Filter
Top Products
32-10
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
78-17058-01
Chapter 32 Configuring IP Unicast Routing
Configuring IP Addressing
Enable Proxy ARP
By default, the switch uses proxy ARP to help hosts learn MAC addresses of hosts on other networks or
subnets.
Beginning in privileged EXEC mode, follow these steps to enable proxy ARP if it has been disabled:
To disable proxy ARP on the interface, use the no ip proxy-arp interface configuration command.
Routing Assistance When IP Routing is Disabled
These mechanisms allow the switch to learn about routes to other networks when it does not have IP
routing enabled:
• Proxy ARP, page 32-10
• Default Gateway, page 32-11
• ICMP Router Discovery Protocol (IRDP), page 32-11
Proxy ARP
Proxy ARP, the most common method for learning about other routes, enables an Ethernet host with no
routing information to communicate with hosts on other networks or subnets. The host assumes that all
hosts are on the same local Ethernet and that they can use ARP to learn their MAC addresses. If a switch
receives an ARP request for a host that is not on the same network as the sender, the switch evaluates
whether it has the best route to that host. If it does, it sends an ARP reply packet with its own Ethernet
MAC address, and the host that sent the request sends the packet to the switch, which forwards it to the
intended host. Proxy ARP treats all networks as if they are local and performs ARP requests for every
IP address.
Proxy ARP is enabled by default. To enable it after it has been disabled, see the “Enable Proxy ARP”
section on page 32-10. Proxy ARP works as long as other routers support it.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Enter interface configuration mode, and specify the Layer 3
interface to configure.
Step 3
no shutdown Enable the interface if necessary. By default, UNIs are disabled
and NNIs are enabled.
Step 4
ip proxy-arp Enable proxy ARP on the interface.
Step 5
end Return to privileged EXEC mode.
Step 6
show ip interface [interface-id] Verify the configuration on the interface or all interfaces.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.