Cisco Systems ME3400G2CSA Switch User Manual


 
32-5
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
78-17058-01
Chapter 32 Configuring IP Unicast Routing
Configuring IP Addressing
Assigning IP Addresses to Network Interfaces
An IP address identifies a location to which IP packets can be sent. Some IP addresses are reserved for
special uses and cannot be used for host, subnet, or network addresses. RFC 1166, “Internet Numbers,”
contains the official description of IP addresses.
An interface can have one primary IP address. A mask identifies the bits that denote the network number
in an IP address. When you use the mask to subnet a network, the mask is referred to as a subnet mask.
To receive an assigned network number, contact your Internet service provider.
Beginning in privileged EXEC mode, follow these steps to assign an IP address and a network mask to
a Layer 3 interface:
IRDP Disabled.
Defaults when enabled:
Broadcast IRDP advertisements.
Maximum interval between advertisements: 600 seconds.
Minimum interval between advertisements: 0.75 times max interval
Preference: 0.
IP proxy ARP Enabled.
IP routing Disabled.
IP subnet-zero Disabled.
Table 32-1 Default Addressing Configuration (continued)
Feature Default Setting
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Enter interface configuration mode, and specify the Layer 3
interface to configure.
Step 3
no shutdown Enable the interface if necessary. User network interfaces
(UNIs) are disabled by default; network node interfaces (NNIs)
are enabled by default.
Step 4
no switchport Remove the interface from Layer 2 configuration mode (if it is a
physical interface).
Step 5
ip address ip-address subnet-mask Configure the IP address and IP subnet mask.
Step 6
end Return to privileged EXEC mode.
Step 7
show interfaces [interface-id]
show ip interface [interface-id]
show running-config interface [interface-id]
Verify your entries.
Step 8
copy running-config startup-config (Optional) Save your entries in the configuration file.