Filter
Top Products
68 Installing Upgrades
www.dell.com | support.dell.com
Removing a Memory Module
NOTICE: Before disconnecting a peripheral from the system or removing a
component from the system board, verify that the standby power indicator on
the system board has turned off. To locate this indicator, see "System Board
Components."
NOTICE: To avoid damage to the memory module, press the securing clips
with equal force applied at each end of the socket.
1
Press the securing clips at each end of the socket outward
simultaneously until the module pops out slightly from the socket (see
the following figure).
2 Lift the module away from the socket.
NOTE: If you remove a module (RIMM or CRIMM), you must install another
module in the empty socket before turning on the computer.
Removing a Memory Module
Installing a Memory Module
1 Press the securing clips at each end of the socket outward until they
snap open (see the following figure).
2 Align the slots on the bottom of the module with the two ridges inside
the socket.
NOTICE: To avoid damage to the memory module, press the module straight
down into the socket with equal force applied at each end of the module.
securing clips (2)