Filter
Top Products
Installing Upgrades 89
bay is engaged. Replace the screw holding the drive bracket to the
drive bay.
Installing the Hard-Drive Bracket (Desktop Chassis)
8
Connect the interface cable for the drive. See "Attaching Hard-Drive
Cables (Desktop Chassis)."
NOTICE: To avoid possible damage, you must match the colored strip on the
interface cable with pin 1 on both the drive and system board connectors.
a If you are installing an EIDE device, ensure that the IDE interface
cable is properly connected to the EIDE connector on the system
board. For more information, see "EIDE Device Installation
Guidelines."
b If you are installing a SCSI device, ensure that the SCSI interface
cable is properly connected to the interface connector on the SCSI
controller board. For more information, see "SCSI Device
Installation Guidelines."
screw
hooks (3)
hard-drive bracket
latch