Filter
Top Products
Convention IDSDM indicator code Condition
E Not lit Indicates that the card is missing or is booting
Next steps
Follow the procedure listed in After working inside your system.
Related References
System board connectors
Installing the internal dual SD module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Locate the internal dual SD module (IDSDM) connector on the system board.
2. Align the connectors on the system board and the IDSDM.
3. Push the IDSDM until it is firmly seated on the system board.
Next steps
1. Install the SD card(s).
Temporarily label each SD card with its corresponding slot before removal. Replace the SD card(s)
into the same slots.
2. Follow the procedure listed in After working inside your system.
Related References
System board connectors
Related Tasks
Installing an internal SD card
Cooling shroud
49