Filter
Top Products
CAUTION: To prevent damage to the IDSDM card, hold the card only by its edges.
NOTE: You must remove the IDSDM card to replace a faulty IDSDM card or service other
components inside the system.
Steps
1. Align the following:
• The slot on the card edge with the projection tabs on the PCIe mezzanine card support.
• The two screw holes on the IDSDM card with the standoffs on the system board.
• The hole on the SD card slot bracket with the screw hole on the IDSDM card.
2. Install the two screws to secure the SD card slot bracket and IDSDM card to the system board.
Next steps
1. If applicable, install the SD card(s) and the internal USB key.
2. Follow the procedure listed in After working inside your system.
Related Links
Replacing the internal USB key
Replacing an SD card
rSPI card (optional)
rSPI (restore Serial Peripheral Interface) is a SPI flash device to store information about the system Service
Tag, system configuration, or iDRAC license.
Removing the rSPI card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the rSPI card to replace a faulty rSPI card or service other components
inside the system.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Keep the #2 Phillips screwdriver ready.
Steps
1. Remove the two screws securing the rSPI card to the system board.
CAUTION: To prevent damage to the rSPI card, hold the card only by its edges.
2. Lift the card away from the system.
66