Filter
Top Products
Figure 29. Removing and installing a 1.8 inch SSD blank
1. SSD blank 2. release latch
Next steps
1. Install the hard drive/SSD. See Installing a hard drive/SSD.
Installing a hard drive/SSD blank
Prerequisites
1. Ensure that you read the Safety instructions.
2. Remove a hard drive/SSD. See Removing a hard drive/SSD.
Steps
Insert the hard drive/SSD blank into the hard drive/SSD slot until the release latch clicks into place.
Shutdown procedure for servicing a hard drive/SSD
NOTE: This section applies only to situations where the sled must be powered down to service a
hard drive/SSD.
If you need to service a hard drive/SSD, turn off the sled and before removing the hard drive/SSD wait for
30 seconds after the sled indicator turns off. Otherwise, the hard drive/SSD may not be recognized after it
is reinstalled and the sled is powered on again.
Configuring the boot drive
The drive or device from which the system boots is determined by the boot order specified in the System
Setup.
82