Filter
Top Products
118 Appendix
www.dell.com | support.dell.com
CAUTION: A new battery can explode if it is incorrectly installed.
Replace the battery only with the same or equivalent type
recommended by the manufacturer. Discard used batteries
according to the manufacturer’s instructions.
1
Record all the screens in system setup (see page 116) so that you can
restore the correct settings in step 7.
2 Open the computer cover (see page 84).
3 Locate the battery socket labeled BATTERY (see page 118).
NOTICE: If you pry the battery out of its socket with a blunt object, be
careful not to touch the system board with the object. Ensure that the object is
inserted between the battery and the socket before you attempt to pry out the
battery. Otherwise, you may damage the system board by prying off the socket
or by breaking circuit traces on the system board.
4
Remove the battery by carefully prying it out of its socket with your
fingers or with a blunt, nonconducting object such as a plastic
screwdriver.
5 Insert the new battery into the socket with the side labeled "+" facing
up, and snap the battery into place.
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
6
Close the computer cover, and plug your computer and devices into
electrical outlets.
7 Access system setup (see page 115) and restore the settings you
recorded in step 1.
8 Properly dispose of the old battery (see page 14).
battery socket
(BATTERY)
battery