Filter
Top Products
90 Adding Parts
www.dell.com | support.dell.com
10 Place the card in the connector and press down firmly. Ensure that the
card is fully seated in the slot.
If the card is full-length, insert the end of the card into the card guide
bracket as you lower the card toward its connector on the system
board. Insert the card firmly into the card connector on the system
board.
11 Before you lower the retention arm, ensure that:
• The tops of all cards and filler brackets are flush with the
alignment bar
• The notch in the top of the card or filler bracket fits around the
alignment guide
Press the arm into place, securing the card(s) in the computer.
fully seated card
not fully seated card
bracket caught
outside of slot
bracket
within slot