Filter
Top Products
98 Adding Parts
www.dell.com | support.dell.com
12 To verify that the memory is installed correctly, check the amount of
memory (RAM) listed.
Adding or Replacing the AGP Card
CAUTION: Before you begin any of the procedures in this section,
follow the steps in "When Working Inside Your Computer" on
page 12.
CAUTION: To guard against electrical shock, always unplug your
computer from the electrical outlet before opening the cover.
Your Dell™ computer provides a connector for an AGP card.
1 Shut down the computer (see page 33).
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
2 Turn off any attached devices and disconnect them from their
electrical outlets.
3 Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
4 Open the computer cover (see page 84).
Removing an AGP Card
1 Remove the filler bracket by raising the hinged lever and sliding the
bracket up.
2 Press the card lever toward the PCI connector.