Filter
Top Products
Installation Instructions IM584000300
Spec. No. 584000300 (Model 4015-X003) Issue AB, April 3, 2013
Chapter 3. Making Electrical Connections Page 23
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Figure 3-7 (cont’d on next page)
Internal Battery Tray Interconnections
Internal/External Battery Tray
Control/Alarm Connectors
(If an internal or external battery tray is
not connected, MUST have termination
plugs installed.) (Use either connector.)
1. Remove a termination plug from one of the
connectors (either one) located on the rear
of the power and control sub-rack.
2. Plug the extension control/alarm cable
into the connector the termination plug was
removed from.
3. Connect the other end of the extension
control/alarm cable into the battery tray
control/alarm harness.
Rear
Rear
Battery Tray
Control/Alarm
Harness
Extension
Control/Alarm
Cable (P/N 554715)
(56”)
Power and Control
Sub-Rack
Battery Tray Alarm / Control Connections - 1 Tray Only
Battery
Tray