Filter
Top Products
Tips for Direct Printing
This section provides information that may help you in using the
direct print function.
Terminating a Direct Print Operation
Direct printing does not stop until
the
whole of the scanning area is
scanned or the scanner is turned off. When the printer is set off line
or
runs
out of paper, the scanner stops sending data. To resume
printing, set the printer on line or load more paper.
To terminate direct printing in the middle of
an
operation, first set
the printer off line to
halt
printing, then turn off the scanner.
Remove the paper from the printer by pressing the
FORM FEED
or
LOAD/EJECT
button; then turn off the printer. (Do not use the platen
knob.)
If you
turn
off the scanner before turning off the printer, the printer
may be unable to go off line. In
this case,
turn the scanner back on,
or turn the printer off and then back
on
again before removing the
paper from
the
printer.
If you turn the printer off and back on again during direct printing,
the scanner initializes itself and terminates direct printing.
Zoom and Printable Size
To allow for margins around the printable area for appropriate
paper feeding and printing, the maximum size of printing is limited
to be within the printable area of the printer type selected. For an 80
column printer, the maximum printable size is approximately
7.1 x 9.3 inches or 200
mm
x 237 mm, and for a 136 column printer,
it is approximately 9.7 x 11.9 inches or 246 mm x 301 mm.
D-18
Direct Print Function