Filter
Top Products
Initialization
There are three ways that the scanner can
be
initialized (returned to
a fixed set of conditions).
Hardware initialization:
l
The power is turned
on.
l
The scanner receives an INIT signal at the parallel interface (pin
31 goes LOW).
Software initialization:
l
The software sends an initialize command.
Default Settings
The table below shows the default conditions that take effect when
the scanner is initialized.
Item
Default
Data format
Resolution
1 bit/pixel
100 dpi for horizontal scan and vertical scan
1
Zoom
1
100% for horizontal scan and vertical scan
Scanning area
848 x 1169 dots, no off set
1
Color mode
1
Monochrome
Brightness
Center “0” (normal)
Halftoning mode
DIP switch setting
Gamma correction
Color correction
DIP switch setting
DIP switch setting
During initialization, the scanner terminates the scanning operation
and returns the carriage to the home position (at the back of the
scanner).
Technical Specifications A-7