Filter
Top Products
Problems and Solutions
Problem
Solution
All or part of the
image is distorted on
the CRT display or
on the printed
output document.
The entire image is
Check that the document is placed flat
distorted or blurred.
against the document table.
Part
of
the image is
distorted or blurred.
The edges
of
the
document are not
scanned.
You may have accidentally moved the
document during scanning. Check the
position of the document again and do
not move it while the scanner is
operating.
The scanner may be tilted or located on
an unstable surface. Check the location of
the scanner, and locate it on a flat, stable
surface.
Part of the document may be wrinkled or
warped or not in contact with the
document table. Make this part flat.
0
I
CAUTION:
Do not place heavy
.
objects on the document table.
If the document glass is dirty, clean it.
The document table has a non-scannable
area around the edges. Adjust the
position of your document so that the
image is inside the scannable area. (See
Chapter 2.)
4-8
Troubleshooting