Filter
Top Products
Connecting the Scanner to the SCSI Interface
This section shows you how to connect the ES-300C to the SCSI
interface. Consult your dealer to obtain the proper SCSI interface
cable.
CAUTION:
If you have a Macintosh Plus, you must first
set DIP switches SW1-1, SW1-2, and SW1-3 on your
scanner to on. (See pages D-4 to D-7 for information on
how to change DIP switch settings.)
Connecting the Scanner as a Single SCSI Device
The simplest connection hooks the computer directly to the scanner.
To connect the scanner to the Macintosh, you need a 25-pin to
50-pin SCSI system cable.
1.
2.
3.
4.
5.
Check that both the scanner and the Macintosh are turned off
and unplugged from the power source.
Connect the 25-pin end of the cable to the SCSI port on the
Macintosh. The SCSI port is the larger port with the diamond-
shaped icon over it. Be sure that the cable is securely connected.
Connect the 50-pin end of the cable to the upper connector on
the SCSI board.
Connect the power cables on both the computer and scanner.
Plug the cables into electrical outlets.
Always turn on the scanner first; then start the computer.
CAUTION:
Do not connect more than one interface cable
C-10 Connecting the Scanner to a Macintosh