Filter
Top Products
91
In most cases, there will be only one NIC, and you can simply select “Next”.
This screen displays only the NICs on this system that are supported by DiskSafe Express.
If no NICs appear on this screen, you might need to install an appropriate network driver.
Select Load Driver, select the location from which you want to install the driver (Load From
System for the local hard disk, Load From Floppy for a floppy disk drive, or Load From
CDROM for a CD-ROM drive), insert the disk in the drive (if loading from a floppy disk or
CDROM), and respond to the prompts. For information about obtaining the appropriate
driver, contact your vendor.
To see a complete list of the detected hardware, select Rescan. When you are done
viewing the list, select “OK”.
4. Review the settings for your NIC and select “Next”.
The recovery CD obtains the IP address to use from your DHCP server. If the displayed
settings are not the ones you want to use, or if no IP address is displayed, select Config
and specify the desired IP address or subnet mask. (If you make a mistake typing either
the IP address or subnet mask, select “Disable” to clear the displayed information.) Then
select “OK” and select “Next”.
5. n the Client Name field, enter the full computer name of this computer. This name is
always uppercase characters.
If you don’t remember the full computer name, access the Manager and click “Backups” in
the navigation bar. In the Protected disks list, the Computer Name column lists the
computer name of each computer that has backed up disks to the storage system.
6. If your computer is a member of a Windows domain, enter the domain name in the Domain
Name field. (If your computer is not a member of a Windows domain, leave this field
blank.)
Initially, the recovery CD will attempt to connect to the storage system using only the
computer name. If this fails, the domain name will be appended as well. This ensures that
your computer can be properly authenticated.
7. In the Recovery Server field, enter the name or IP address of the storage system where
the backups reside.
8. Make sure the selected authentication type is CHAP. DiskSafe Express supports only
CHAP authentication.
9. In the Recovery Password field, enter the recovery CD password that you specified when
you protected the disk or when you last changed the password.