Filter
Top Products
c39 frank
Testing and Adjusting
3-25
3
Aligning the TTR Supply Hub
You should align the TTR supply hub only if you are experiencing ribbon
wrinkle on full width
ribbon after the rollers and printhead have been aligned.
To perform this procedure, you need the following tools:
• TTR supply hub alignment tool, Intermec Part No. T43149
• #2 Phillips screwdriver
To align the TTR supply hub
1. Switch off the printer power.
2. Remove the media cover and the electronics cover.
3. Install the TTR supply hub alignment tool as shown.
3600M.041
Ribbon supply
hub alignment
tool
4. Tighten the alignment tool thumbscrew so the bushing tab is flush against
the bushing on the hub adjustment plate.
5. Loosen the two screws securing the hub adjustment plate.
6. Switch on the printer power.
7. Print a series of the same kind of labels that were having the ribbon
wrinkling problem. While they are printing, adjust the TTR supply hub up
or down (with the thumbscrew on the tool) until ribbon wrinkling is
eliminated.