Filter
Top Products
US Federal Communications Commission
FCC Part 15 Compliance Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
WARNING! Any changes or modifications to the fax accessory that are not expressly approved by HP
could void the user's authority to operate this equipment.
NOTE: Use of a shielded interface cable is required to comply with the Class A limits of the FCC rules
FCC Part 68 Telecom
If requested, you must be prepared to provide the telephone company with the following information for
the SocketModem card included within this product:
Manufacturer: Multi-Tech Systems, Inc.
2205 Woodale Drive
Mounds View, MN 55112
USA
Trade Name: Modem Module
Model Number: MT5634SMI
FCC Registration No: AU7-USA-25814-M5-E
Ringer Equivalence: 0.3B
Modular Jack (USOC): RJ11C or RJ11W (single line)
Service Center in USA: U.S.A.
(763) 785-3500
(763) 785-9874 Fax
The equipment complies with FCC Rules, Part 68. The Socket Modem Module has a label that contains,
along with other information, the FCC registration number and ringer equivalence number (REN) for this
equipment. If requested, this information must be provided to the telephone company. The REN is used
to determine the quantity of devices which may be connected to the telephone line. Excessive RENS
on the telephone line may result in the devices not ringing in response to an incoming call. In most, but
not all areas, the sum of the RENS should not exceed five (5.0). To be certain of the number of devices
that may be connected to the line, as determined by the total RENS, contact the Telephone Company
to determine the maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C or RJ11W (single line)
130 Appendix C Regulatory Information ENWW