Filter
Top Products
3-32 Loading Rigid Media
4. Enter the length of the media.
The printer will use the value you enter here for subsequent
calculations, so be as accurate as possible.
5. Press the ! key.
The control panel displays the prompt:
Load a sheet of media onto the printer
6. Unload any roll-fed media from the printer.
7. Insert the pins of the media alignment tool into two platen
vacuum holes (in the same row).
8. Release the pinch rollers.
9. Slide a sheet of media onto the platen and center it on the
pinch rollers.
It is not necessary to align the media to the left or right edge
of the platen. If possible, avoid positioning the left or right
edge of the media under a pinch roller. If this is unavoid-
able, see “Releasing a Pinch Roller,” on the next page.
Fig. 3-15. Media alignment tool