Filter
Top Products
Chapter 3. Upgrading the Enterprise Virtual Array to v3.020
Step 6: Upgrading Command View EVA
Estimated T ime to Complete
45 minutes
This section contains the following procedures:
• Upgrading to Command View EVA v3.2
• Verifying the Command View EVA version
You must upgrade to Storage Management Appliance software v2.1, before you upgrade to
Command View EVA v3.2. (See “Step 3: Upgrading the Storage Management Appliance”for
more information.)
You must be running HSV Element Manager v2.0 or later to upgrade to Command View
EVA v3.2. You cannot upgrade from HSV Element Manager v1.0 to Command View EVA
v3.2. To upgrade from HSV Element Manager v1.0 to HSV Element Manager v2.0, please
refer to SANworks by Compaq Upgrade Instructions for Enterprise Virtual Array. Table 3.3
describes the proper upgrade paths to Command View EVA v3.2.
Table 3.3. Command View EVA Upgrade Paths
Current Command View
EVA Version
Upgrade Path
HSV Element Manager v2.0
HSV Element Manager v2.0a
Command View EVA v2.1
Command View EVA v3.0
Command View EVA v3.0a
1. Upgrade to Command View EVA v3.1
2. Upgrade to Command View EVA
v3.2.
Command View EVA v3.1 Upgrade to Command View EVA v3.2.
The installation of Storage Management Appliance software v2.1 automatically installed
Command View EVA v3.0a over your previous element manager version.
To verify which version of Command View EVA you are using, see Verifying the Command
View EVA version for assistance.
Upgrading to Command View EVA v3.2
Note
Remember to remove the passwords from the HSV controllers and Command View EVA (or HSV
Element Manager) before you upgrade to Command View EVA v3.2 (See Step 5: Clearing the
passwords on the HSV controllers).
To upgrade to Command View EVA v3.2:, perform the following steps:
1. Close all browser windows, Microsoft® Management Console (MMC) sessions,
Terminal Services sessions, and Java applets that are open to and on the Storage
Management Appliance.
hp StorageWorks Enterprise Virtual Array Updating Product
Software Instructions
51