Filter
Top Products
Chapter 3. Upgrading the Enterprise Virtual Array to v3.020
Note
ThedefaultappliancenameforaStorageManagementAppliance(hardwareversion1.0)
begins with
swma
and includes the last 6 characters of the appliance serial number.
If the Storage Management Appliance software was restored using the Quick Restore CD v2.0,
thenthedefaultappliancenamebeginswith
sma
and includes all 12 characters (10 characters
for Storage Management Appliance III) of the appliance serial number.
The default a
ppliance name for a Storage M anagement Appliance II begins with
sma
and
includes all
12 characters (10 characters for Storage Management Appliance III) of the
appliance serial number.
The serial number is displayed on a sticker which is usually pasted to the lower right side of
theappliance(whenviewedfromthefront).
3.
In the Enter Network Password page, type your User Name and Password, and click OK.
The Storage Management Appliance software home page displays.
4.
Click Settings.
5.
Click Maintenance.
6.
Click Remove Software.
The Remove Application page displays.
7.
Click hp StorageWorks SMI-S for EVA.
8.
Click Remove.
The Remove Application page displays a remove application confirmation message.
9.
Click OK to remove SMI
-S EVA.
The following message displays:
Application has been removed.
See below for details (if any).
hp StorageWorks SMI-S for EVA <Date> <Time>
Uninstall Complete.
Caution
Clicking OK in step 9 initiates the removal of SMI-S EVA software from the
Storage M anagement Appliance.
10.
Verify that the hp StorageWorks SMI-S for EVA entry is not present on the Manage
Tools page.
Installing SMI-S EVA on the Storage Management Appliance
You can use two methods to install the SMI-S EVA software:
• Installing from a CD-ROM
• Installing from a local disk on the Storage Management Appliance
See Troubleshooting SMI-S EVA for help with common SMI-S EVA problems.
hp StorageWorks Enterprise Virtual Array Updating Product
Software Instructions
85