Filter
Top Products
Chapter 3. Upgrading the Enterprise Virtual Array to v3.020
Note
In some cases, the message, Rebooting this Appliance,isdisplayed.
If the installation fails for any reason, the Storage Management Appliance does not permit
a subsequent installation attempt for one hour following the failed attempt. Attempting an
installation during this one hour period displays an error message.
19.
Click Finish.
20. Verify whether an SMI-S EVA entry exists on the Manage Tools page in the Storage
Management Appliance software.
To view the Manage Tools page, click Settings on the Storage Management Appliance
home page, and then click Manage Tools.
If an SMI-S EVA entry is displayed, the installation is complete.
If the entry is not displayed, complete one of the following procedures:
• Go to step 8 and repeat the installation procedure.
• Delete the files in the C:\Program Files\Hewlett-Packard\hp
SMI-S\EVAProvider folder.Gotostep8andrepeatthe installation procedure.
Note
The CIMOM, b y default , runs on the 5 9 88 port .
Verifying SMI-S EVA installation
To verify the SMI-S EVA installation, complete the following procedure:
1.
Verify that hp StorageWorks SMI-S for EVA is listed under Application on the Manage
Tools page in the Software Management Appliance software.
To access the Manage Tools page, click Settings on the Storage Management Appliance
home page and then click Manage Tools.
2. Verify that the directory C:\Program Files\Hewlett-Packard\SMI-S
\EVAProvider exists on the Storage Management Appliance.
Configuring SMI -S EVA
You must complete the post-installation steps in this section before you can use SMI-S EVA.
Post installation steps
After SMI-S EVA is installed, add 127.0.0.1 to the list of recipients who receive events
generated by every HSV pair connected to the management appliance. This can be done using
the hp StorageWorks Storage Management Appliance software. In addition, configure the
event and host notifications as indicated in Configuring event and host notifications.
The configuration files for setting up the SMI-S EVA service are in the following directory
where SMI-S is installed: C:\Program Files\Hewlett-Packard\SMI-S\cimom.
hp StorageWorks Enterprise Virtual Array Updating Product
Software Instructions
89