Power supply fan and fan duct
Before proceeding, remove the following components:
●
Toner collection unit. See
Toner collection unit on page 79.
●
Right rear cover. See
Right rear cover on page 109.
●
Left cover. See
Left cover on page 111.
●
Rear cover and upper rear cover. See
Rear cover and upper rear cover on page 124.
NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the
power supply fan.
Remove the power supply fan and fan duct
1. Disconnect one connector (callout 1; J119) and release the wire harnesses from the guide
(callout 2).
NOTE: To locate DC controller connector locations, see DC controller PCA on page 284.
Figure 2-113 Remove the power supply fan (1 of 4)
1
2
ENWW
Internal assemblies
147