Filter
Top Products
5. Press the OK button again.
6. Press the back arrow
button to highlight Continue, and then press the OK button.
NOTE: The product initializes.
Clean Disk
The Clean Disk option erases the entire disk drive.
CAUTION: After executing a Clean Disk option, the product is not bootable.
Characteristics of a Partial Clean
●
Customer-defined settings, third-party solutions, firmware files, and the operating system are
deleted.
NOTE: Rebooting the product does not restore the firmware files.
●
Rebooting the product restores the firmware files from the Repository location, but does not restore
any customer-defined settings.
●
After executing the Clean Disk function, the message 99.09.67 displays on the control panel.
●
After executing the Clean Disk function, the product firmware must be reloaded.
CAUTION: HP recommends that you do not use the Clean Disk option unless an error occurs and
the solution in the product service manual recommends this solution. After executing the Clean Disk
function, the product is unusable.
HP recommends backing-up product configuration data before executing a Clean Disk if you need to
retain customer-defined settings. See the Backup/Restore item in the Device Maintenance menu.
Reasons for performing Clean Disk
●
The product continually boots up in an error state.
NOTE: Try clearing the error prior to executing a Clean Disk.
●
The product will not respond to commands from the control panel.
●
Executing the Clean Disk function is helpful for troubleshooting hard disk problems.
●
To reset the product by deleting all solutions and customer-defined settings.
Execute a Clean Disk
1. Turn the product on.
2. When the Ready, Data, and Attention LEDs are illuminated solid, press the Stop
button.
3. Press the Down arrow
button to highlight Administration, and then press the OK button.
512 Chapter 3 Solve problems ENWW