Filter
Top Products
Table 3-46 Causes and solutions for pickup delay and pickup stationary jams (continued)
Cause Solution
The Tray 3 feed sensor lever is set incorrectly
or damaged.
Check the sensor lever to make sure it is set correctly. If it is damaged, replace
the paper-feeder assembly.
The spring of the Tray 3 feed sensor lever is
unhooked.
Check the spring and place it in correct position.
Poor contact of the Tray 3 feed sensor
connector.
Reconnect the connector (J405) on the paper feeder driver PCA intermediate
connector (J13) and connector (J20) of the Tray 3 feed sensor.
The Tray 3 feed sensor is defective. Run a sensor test to verify that the Tray 3 feed sensor is functioning properly. If
it is not, replace the paper-feeder assembly.
Change jam recovery
This product provides jam recovery, a feature that you can use to reprint jammed pages. The following
options are available:
●
Auto — The product attempts to reprint jammed pages when sufficient memory is available.
●
Off — The product does not attempt to reprint jammed pages. Because no memory is used to
store the most recent pages, performance is optimal.
NOTE: When using this option, if the product runs out of paper and the job is being printed on
both sides, some pages can be lost.
●
On — The product always reprints jammed pages. Additional memory is allocated to store the
last few pages printed. This might cause overall performance to suffer.
1.
At the product control panel, press the Home
button.
2. Open the following menus:
●
Administration
●
General Settings
●
Jam Recovery
3. Select the appropriate setting, and then press the OK button.
ENWW
Clear jams
491