Reinstall the main drive assembly
1. Remove the bracket (callout 1), two guides (callout 2), and the developing disengagement motor
(callout 3).
Install the bracket and guides on the replacement main drive assembly.
NOTE: Do not install the developing disengagement motor on the assembly (this motor must be
removed from the assembly to align the main drive cams).
Figure 2-206 Reinstall the main drive assembly (1 of 11)
3
2
1
2. Locate the cams (callout 1) on the back side of the assembly.
Figure 2-207 Reinstall the main drive assembly (2 of 11)
1
ENWW
Internal assemblies
217