Filter
Top Products
Drum motor 2 or drum motor 3
Before proceeding, remove the following components:
●
Toner collection unit. See
Toner collection unit on page 79.
●
Formatter PCA. See
Formatter PCA on page 81.
●
Right rear cover. See
Right rear cover on page 109.
●
Left cover. See
Left cover on page 111.
●
Hardware integration pocket (HIP). See
Hardware integration pocket (HIP) (dn and xh models
only) on page 115.
●
Control panel assembly. See
Control panel assembly on page 116.
●
Front top cover. See
Front top cover on page 122.
●
Rear cover and upper rear cover. See
Rear cover and upper rear cover on page 124.
NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove drum
motor 2 or drum motor 3.
●
Rear top cover. See
Rear top cover on page 127.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 158.
●
DC controller. See
DC controller PCA and tray on page 160.
●
Low voltage power supply. See
Low voltage power supply on page 163.
●
High voltage power supply upper. See
High voltage power supply upper (HVPS-T) on page 201.
208 Chapter 2 Removal and replacement ENWW