Automatic close assembly
Before proceeding, remove the following components:
●
Toner collection unit. See
Toner collection unit on page 79.
●
Formatter. See
Formatter PCA on page 81.
●
Right rear cover. See
Right rear cover on page 109.
●
Left cover. See
Left cover on page 111.
●
Rear cover and upper rear cover. See
Rear cover and upper rear cover on page 124.
NOTE: It is not necessary to separate the upper rear cover from the rear cover to remove the
lifter drive assembly.
●
Interconnect board (ICB). See
Interconnect board (ICB) on page 158.
●
Low voltage power supply. See
Low voltage power supply on page 163.
●
High voltage power supply lower. See
High voltage power supply lower (HVPS-D) on page 167.
●
Lifter drive assembly. See
Lifter drive assembly on page 173.
Remove the automatic close assembly
▲
Remove one screw (callout 1), and then remove the assembly.
Figure 2-149 Remove the automatic close assembly
1
ENWW
Internal assemblies
175