Filter
Top Products
3-23Installation and Configuration
Table 3-2. State Messages (Continued)
Message State
Pen palette
saved
The pen source, pen number widths, and pen number shades you just en-
tered have been saved as either Palette A or Palette B (whichever you
specified).
Returning pens The pen carriage is returning to its station at the left of the plotter.
Roll feed
Edge trim
Machine is trimming the edge of roll media.
RS-232 config
loaded
The RS-232-C configuration you just entered (Config A, Config B, or
Factory) has been loaded.
RS-232 config
saved
The baud, handshake, and parity settings you just entered for your
RS-232-C configuration have been saved as either Config A or Config B
(whichever you specified).
STATUS
Initializing
Machine is doing internal checking upon power-up.
STATUS
Out of media
The plotter has detected that the roll is empty (you must be in Roll mode
for this to happen). If desired, remove the old roll and insert a new one.
STATUS
Plotting
Machine is plotting.
STATUS
Ready for media
Machine is ready for you to load media.
STATUS
Ready to plot
Machine is ready to plot.
STATUS
Receiving
Machine has received plot data.
Testing pens The machine is testing the pens for problems, i.e., clogged pen or bad
electrical connection (improper seating).